To install the steam fireplace correctly, leave at least 5 cm of ventilation space on all sides, and use a wall-mounted 220–240V grounded socket (do not place the power outlet on the floor).
This model produces cool mist without heat, so no heat insulation is required.

1. Place the fireplace on a stable, level surface.
2. Insert the tube into the first hole on the right.
3. Press the power button.
4. The fireplace will automatically fill the tank until you hear: “ Fuel is full."
5. Remove the tube. the fireplace is ready to use

A full tank allows continuous operation for about 7 hours.

Yes.

Remove the tube after the tank is full and the unit is ready to use. A full tank allows continuous operation forabout 7 hours.

1. Prepare a container to collect water.
2. Insert the tube into the second hole on the left .
3. Press the “ + ” and “ – ” buttons together to start automatic draining.
4. When the water level is low, lift one side slightly to remove the remaining water.
   

• Use purified or filtered water to protect the sensor and prevent limescale buildup, which can reduce flame.
• Do not reuse drained water.
• Do not add essential oils or fragrances, as this may damage the mist system.
• When filling the tank, keep the fireplace higher than the water container to allow smooth water flow.
• Empty the tank before moving the unit.
• If you will not be using the fireplace for a long period, drain the tank to prevent odors and sediment buildup.

This usually happens when there is insufficient airflow around the unit. Make sure there is at least 5 cm of ventilation space on all sides and at the bottom to allow the mist to rise properly.

For best results, clean the unit once a month, avoid using essential oils, and use 60–100 ml of Eblth Cleaning Solution for cleaning.

This usually happens when the mist system needs cleaning.

Avoid essential oils, and use Eblth Clean Solution to clean the tank once a month. Routine maintenance helps restore full and even mist output.

To clean your mist fireplace, follow these simple steps:

1. Use Eblth Cleaning Solution.
2. Pour one full bottle into the tank, then add water.
3. Let it sit for 30 minutes, then empty the tank completely (do not reuse this water).
4. Rinse the tank with clean water and empty it again for best results.
5. Refill the tank with fresh water — you’ll notice stronger, clearer flame.
   

Remember:

• Clean your Steam Fireplace once a month, and never use essential oils or fragrances.

To install the electric fireplace, ensure there’s a small gap (about 1 cm) at the top for heat ventilation. It can be installed within a cabinet or wall without any issues.

The heating temperature in the Eblth fireplace is fixed at 1500 watts and cannot be manually adjusted.

You can only turn the heating function on or off using the remote control or the operation panel.

This is a safety feature.

The heater may automatically shut off once the room temperature reaches the set level. It will restart when the temperature drops again.